DIAGNOSTICS & TROUBLESHOOTING
n
5-3
Service Diagnostics
Voltage Measurement Safety Information
When performing live voltage measurements, you must do the following:
Verify the controls are in the off position so that the appliance does not start when energized.
Keep other people a safe distance away from the appliance to prevent potential injury.
DANGER
Electrical Shock Hazard
Only authorized technicians should perform
diagnostic voltage measurements.
After performing voltage measurements,
disconnect power before servicing.
Failure to follow these instructions can result in
death or electrical shock.
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
IMPORTANT: Always used the Technical Data Sheet shipped with the product. The tech sheet informaon
depicted in this Job Aid is an example only.
ENTERINg dIAgNOsTIc MOdE
Entering and using the diagnosc
roune takes a lile pracce to
become familiar with the process.
Ulize wa meter during
diagnoscs
Make sure to press CLEAN then
ON – but not both at same me.
Both the Clean and On buons
must be acvated together. Press
and hold the clean buon rst
and then press and hold the On
buon.
t,/Z>WKK>KZWKZd/KE KE&/Ed/> ϯϬ
EdZ/E'/'EK^d/DK
Zz^d>ϱϬη/D,/EͲϮϬϭϯdϯ
dƵƌŶƚŚĞƉƌŽĚƵĐƚŽŶtŝƚŚŝŶϮϬƐĞĐŽŶĚƐŽĨWŽǁĞƌKŶƉƌĞƐƐ
ĂŶĚŚŽůĚƚŚĞůĞĂŶďƵƚƚŽŶƚŚĞŶƚŚĞKEďƵƚƚŽŶƚŽŐĞƚŚĞƌ
WƌĞƐƐĐůĞĂŶ
ϭ
Ɛƚ
ĂŶĚŚŽůĚ
Ϯ
ŶĚ
WƌĞƐƐKEK&&
ĂŶĚŚŽůĚ
To Next Page
Loading...
Need help?
General
