Kenwood DMX6018BT User Manual

50 ENGLISH
SettingsSettings
<Fader/Balance>
Touch [J]/[K]/[H]/[I] or drag the mark to adjust.
<Fader>
Adjusts the front and rear speaker output balance.
When using a two-speaker system, set the fader to the
center (0).
• F15 to R15 (Initial: 0)
<Balance>
Adjusts the left and right speaker output balance.
• L15 to R15 (Initial: 0)
To clear the adjustment: Touch [Center].
<Volume Offset>
Adjust and store the auto-adjustment volume level
for each source. The volume level will automatically
increase or decrease when you change the source.
If you have increased the volume first, then reduced
the volume using the Volume Offset, the sound
generated if you suddenly switch to another source
may be extremely loud.
• –5 to +5 (Initial: 0)
To initialize the setting value: Touch [Initialize].
<Sound Effect>
Adjust the sound effect.
<Bass Boost>
Selects the bass boost level.
• OFF (Initial)/1/2/3
<Loudness>
Adjusts loudness. (The LOUD indicator lights up when
the loudness is adjusted.)
• OFF (Initial)/Low/High
<Drive Equalizer>
Reduces the driving noise by raising the bandwidth.
• OFF (Initial)/ON
<Space Enhancer>*
Virtually enhances the sound space using the Digital
Signal Processor (DSP) system. Select the enhance
level.
• OFF (Initial)/Small/Medium/Large
<Supreme>
Restores the sound lost due to audio compression to a
realistic sound.
• OFF/ON (Initial)
<Realizer>
Virtually makes the sound more realistic using the
Digital Signal Processor (DSP) system. Select the sound
level.
• OFF (Initial)/1/2/3
<Stage EQ>
Moves the localization of the sound image to the
lower or higher point. Select the height.
• OFF (Initial)/Low/Middle/High
* You cannot change the setting when “HD Radio” or “Radio” is
selected as the source.
AV settings
Display the <AV> screen.
On the Home screen, touch as follows:
Then, on the <SETUP> screen, touch [AV].
BluetoothSpecial
AV Display Camera
User Interface
SETUP
E.g. Setup screen for DDX795
<TV Tuner Control>
(Only for DDX6018BT/DMX6018BT/DDX5018BT/
DDX718WBTL/DMX718WBTL)
• ON: Enables control of TV operation on “AV-IN”.
• OFF (Initial): Select this to use “AV-IN” with
components other than TV Tuner.
<OEM SETUP>*
(Only for DDX795/DDX775BH/DDX595/DDX575BT)
Confirm the information or change the settings for
using the ADS adapter.
* Appears only when an ADS adapter is connected to the iDatalink
input terminal. (Page66)
ENDDX2018TCKR.indb50ENDDX2018TCKR.indb50 2017/11/3015:352017/11/3015:35

Kenwood DMX6018BT Specifications

General

Brand	Kenwood
Model	DMX6018BT
Category	Car Receiver
Language	English