11
SELECTING A FREQUENCY
VFO MODE
This is the basic mode for changing the operating frequency. Rotate the ENC
control clockwise to increase the frequency and counterclockwise to decrease
the frequency.
MHz TUNING MODE
If the desired operating frequency is far away from the current frequency, it is
quicker to use the MHz Tuning Mode.
To adjust the MHz digit:
1 Press [F].
• The MHz digit blinks.
2 Rotate the ENC control to select the desired MHz value.
3 After selecting the desired MHz value, press [F] or [ENT] to exit the MHz
Tuning Mode and return to normal VFO Mode.
4 Continue adjusting the frequency as necessary, using the ENC control.
TRANSMITTING/ RECEIVING
1 To transmit, hold the transceiver approximately 5 cm (2 inches) from your
mouth, then press and hold [PTT] and speak into the microphone in your
normal tone of voice.
• The TX-RX LED lights red.
2 When you finish speaking, release [PTT].
• The TX-RX LED lights green while receiving a signal.
Note: If you continuously transmit for longer than the time specified in Menu No. 19 (default
is 10 minutes), the internal time-out timer generates a warning beep and the transceiver
stops transmitting. In this case, release [PTT] and let the transceiver cool down for a while,
then press [PTT] again to resume transmitting.
To Next Page
Loading...
Need help?
General
