39
CROSS TONE
You can set separate signaling types by TX and RX for when you access a
repeater that uses different encode/ decode signaling.
1 Press [TONE] 4 times to activate the Cross Tone function.
• Each time you press [TONE], the selection changes as follows:
Tone (
) ➡ CTCSS ( ) ➡ DCS ( ) ➡ Cross Tone ( ) ➡ Off (no display).
• The “
” icon appears when the Cross Tone function is ON.
2 Press [T.SEL].
• The Cross Tone setting appears on the display.
3 Rotate the ENC control to select your desired Cross Tone setting.
Setting TX RX Icon <TX> Icon <RX>
DCS/– DCS off
T/DCS Tone DCS
DCS/CT DCS CTCSS
T/CT Tone CTCSS
• To exit the Cross Tone selection, press [PTT].
4 Press any key other than [MONI], [LAMP], or [PTT] to set the selected setting.
To Next Page
Loading...
Need help?
General
