EasyManuals Logo
Home>Komatsu>Construction Equipment>D65EX-18

Komatsu D65EX-18 User Manual

Komatsu D65EX-18
483 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #323 background imageLoading...
Page #323 background image
LOADING AND UNLOADING WITH TRAILER
kk
WARNING
Since loading and unloading of the machine is dangerous, be extremely careful.
When loading or unloading the machine, lower the engine speed, set the speed range to the 1st, and
operate slowly.
Use ramps with ample width, length, thickness, and strength and install them with a maximum slope
of 15°.
If the ramps deflect much, reinforce them with blocks, etc.
Load the machine on a flat and firm ground.
Secure sufficient distance from the road edge.
Remove mud, etc. from the undercarriage of the machine so that the machine does not slip side-
ways on the ramps.
In addition, remove water, snow, ice, grease, oil, etc. from the ramps.
Never correct your steering on the ramps. There is danger that the machine may tip over.
If necessary, drive off the ramps or back on to the trailer and correct the direction.
The center of gravity of the machine shifts suddenly at the joint between the ramps and the trailer,
and it is dangerous that the machine loses its balance. Pass slowly.
When loading or unloading the machine, be sure to use ramps or platform, and follow the procedure shown be-
low.
PROCEDURES FOR LOADING MACHINE
Load on a firm and level ground.
1.
Park a trailer on a firm and level ground.
Maintain a safe distance from the road shoulder
2.
Apply the brake of the trailer securely.
3.
Set chocks (1) to the tires to secure the trailer.
4.
Install ramps (2).
Set gap (3) between ramps (2) to match the distance be-
tween the right and left tracks, and keep angle (4) to a
maximum of 15 °.
If ramps (2) bend appreciably under the weight of the ma-
chine, put wooden block (5) under the ramps to support
them.
5.
Start the engine.
In a cold weather, perform an engine warm-up operation, referring to “METHOD FOR STARTING ENGINE
IN COLD WEATHER (3-194)”.
6.
When transporting the machine with the work equipment installed to it, raise the work equipment.
1)
Set the work equipment lock lever to FREE position
(F).
2)
Operate the blade control lever and raise the work
equipment.
TRANSPORTATION OPERATION
3-268

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Komatsu D65EX-18 and is the answer not in the manual?

Komatsu D65EX-18 Specifications

General IconGeneral
BrandKomatsu
ModelD65EX-18
CategoryConstruction Equipment
LanguageEnglish

Related product manuals