METHOD FOR CHANGING OIL IN FINAL DRIVE CASE
WARNING
• Immediately after the engine is stopped, its parts and oil are still very hot and may cause burn in-
jury. Accordingly, wait until they have cooled down before starting the work.
• If there is remaining pressure inside the case, the oil or plug may jump out. Loosen the plug slowly
to release the pressure.
Refill capacity:
D65EX (other than power angle power tilt dozer): 16.5 ℓ (4.36 U.S.Gal)
D65EX (power angle power tilt dozer), D65PX, D65WX: 22 ℓ (5.81 U.S.Gal) each on right and left sides
Prepare containers to catch drained oil.
1.
Stop the machine so that drain plug (1) is directly at the
bottom.
2.
Place the oil containers to catch oil under drain plugs (1)
and (4).
3.
Remove oil level plug (2) and oil filler plug (3).
4.
Remove drain plugs (1) and (4) and drain the oil.
5.
After draining the oil, install drain plugs (1) and (4).
6.
Add oil through the hole of oil filler plug (3).
7.
After adding the oil, check that the oil level is proper.
For the check of oil level, see “METHOD FOR CHECKING
OIL LEVEL IN FINAL DRIVE CASE, ADDING OIL (4-57)”.
8.
Install oil level plug (2) and oil filler plug (3).
MAINTENANCE PROCEDURE MAINTENANCE
4-72
To Next Page
Loading...
Need help?
General
