5.
Clean the space between the front surface of the hydraulic
oil cooler and the rear surface of the radiator.
1)
Remove mounting bolt (4).
2)
Remove cover (3).
3)
Use compressed air to blow off the mud, dirt, or
leaves clogging the space.
METHOD FOR CLEANING HYDRAULIC TANK BREATHER
At the check and maintenance, if the breather is dirty, clean it.
1.
Remove nut (2) of breather assembly (1) on the top of the
hydraulic tank.
2.
Remove cover (3).
3.
Remove dirt sticking to breather element (4).
4.
Clean in clean diesel fuel or flushing oil.
5.
Install cover (3) and nut (2).
Tightening torque: 10 to 14 Nm {1.0 to 1.4 kgm, 7.2 to
10.1 lbft}
MAINTENANCE MAINTENANCE PROCEDURE
4-35
To Next Page
Loading...
Need help?
General
