DELUXE SEAT ATTACHMENTS, OPTIONS
6-12
DELUXE SEAT 6
(Rotating seat)
ADJUSTMENT 6
WARNING
When adjusting the position of the operator's seat, always set the work equipment lock lever to the LOCK
position to prevent any accidental contact with the control levers.
q Always adjust the operator's seat before starting each operation or when the operators change shift.
q When adjusting the seat, put your back against the backrest and adjust to a position where the brake pedal
can be fully depressed.
(A) Fore-and-aft adjustment
Pull lever (1), set the seat to a position where it is easy to oper-
ate, then release the lever.
Fore-aft adjustment: 160 mm (6.3 in) (8 stages)
(B) Weight adjustment of seat
Turn knob (2) under the seat to match the weight adjustment
scale with your own weight.
The weight can be adjusted within a range of 50 to 120 kg (110
to 265 lb)
If you want to make the seat softer, turn the weight adjustment to a lower weight; if you want to make the seat
harder, adjust to a higher weight.When operating on uneven surfaces, adjust the seat to a harder setting.
(C) Adjust reclining angle
NOTICE
When reclining the seat back to the rear, check the space behind, and adjust to a suitable position.
Pull lever (3), set the seatback to a position where it is easy to operate, then release the lever.
To Next Page
Loading...
Need help?
General
