Konica Minolta bizhub 4000P User Manual

User's Guide
- 93 -
Use
To
Network Buffer
Auto
3KB to [maximum size
allowed]
Set the size of the network input buffer.
Notes:
• Auto is the factory default setting.
• The value can be changed in 1-KB increments.
• The maximum size allowed depends on the amount of memory in the
printer, the size of the other link buffers, and whether Resource Save is set
to On or Off.
• To increase the maximum size range for the Network Buffer, disable or
reduce the size of the USB buffers.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Mac Binary PS
On
Off
Auto
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
• Auto is the factory default setting.
• Off filters print jobs using the standard protocol.
• On processes raw binary PostScript print jobs.
STD NET SETUP
Reports
Network Card
TCP/IP
IPv6
Wireless
AppleTalk
Display and set the printer network settings.
Note: The Wireless menu appears only when the printer is connected to a
wireless network.
Reports menu
To access the menu, navigate to any of the following:
• Network/Ports menu >Networks/Ports >Standard Network >STD NET SETUP >Reports
Use
To
Print Setup
Page
Print a report containing information about the network printer settings, such as the TCP/IP
address.

Konica Minolta bizhub 4000P Specifications

General

Print Technology	Laser
Print Speed	Up to 42 ppm
Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 100, 000 pages
Standard Output Capacity	150 sheets
Memory	256 MB
Supported Operating Systems	Windows, Mac OS, Linux
Duplex Printing	Automatic
Connectivity	USB 2.0, Ethernet
PDL	PCL 6, PostScript 3, XPS
Processor Speed	1.2 GHz