Malfunctions - Causes and Remedies
62
Pos: 116.1 /Üb erschriften/Üb erschriften 1/P-T/S törungen - Ursac hen und Be hebung @ 0\ mod_120029692 5180_78.doc @ 39459
16 Malfunctions - Causes and Remedies
Pos: 116.2 /Üb erschriften/Üb erschriften 2/P-T/S pezielle Sich erheitshinweis e @ 0\mod_119 6660495760_ 78.doc @ 9134
16.1 Special Safety Instructions
Pos: 116.3 /BA/Sic herheit/Gefa hrenhinweise/L adewagen/Ge fahr Wartung allg emein @ 0\m od_11998840 69862_78.doc @ 36704
Danger! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving.
Effect: Danger to life, injuries or damage to the machine.
• Switch off the tractor engine and remove the ignition key
• Secure the machine and tractor against the possibility of rolling back.
• Switch off the PTO and disengage it
• After the repair, maintenance and cleaning work or technical interventions are completed,
mount all protective coverings and safety devices properly again.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a
physician immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 116.4 /BA/S törungen - Ursa chen und Be hebung/Sch wader/Tabellarisc he Auflistung Sc hwader 46 T @ 7\mod_1 218454258483_ 78.doc @ 10696 6
Malfunction Possible cause Remedy
Rotor not working neatly Raking height set too high Set raking height lower
The working speed is too high. Reduce the driving speed. Rough
estimate 8-10 km/h. For uneven
terrain and/or higher amount of
forage, it may be necessary to
drive slower.
Speed is too low Increase the speed. Rough guide
450 rpm
Side rotor inclination set
incorrectly.
Change side inclination setting
(see chapter on operation entitled
"Side inclination setting of rotor
running gear").
Tine arm(s) crooked Replace tine arms
High level of forage contamination Raking height set too low Set raking height higher
Tine arm(s) bent Replace tine arms
Swath width too large Working width too large
Push swath former further in.
Speed is too low Increase speed
===== Ende der Stückliste ==== =
To Next Page
Loading...
Need help?
General
