KTM 125 Duke 2017 User Manual

14 WHEELS, TIRES 119
F00754-11
–
Clean the thread of the wheel spindle and screw
2
.
– Clean and grease wheel spindle.
Long-life grease (
p. 188)
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel spindle M8 25 Nm
(18.4 lbf ft)
–
Position wheel speed sensor
3
in the drill hole.
–
Mount and tighten screw
4
.
Guideline
Screw, wheel speed sensor holder M6 8 Nm (5.9 lbf ft)
–
Mount and tighten screws
5
with the washers.
Guideline
Screw, front fender M6 7 Nm (5.2 lbf ft)
– Operate the hand brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
– Take the motorcycle from the front lifting gear. (
p. 90)
– Remove the rear of the motorcycle from the lifting gear. ( p. 88)
– Operate the front brake and compress the fork a few times firmly.
The fork legs straighten.
–
Tighten screws
6
.

KTM 125 Duke 2017 Specifications

General

Displacement	124.7 cc
Bore x Stroke	58 mm x 47.2 mm
Compression Ratio	12.6:1
Power	15 hp (11 kW) @ 10, 000 rpm
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Rear Suspension	WP monoshock
Seat Height	830 mm
Ground Clearance	185 mm
Dry Weight	137 kg
Engine Type	Single cylinder, 4-stroke
Torque	12 Nm @ 8, 000 rpm
Frame	Steel trellis frame, powder coated
Front Suspension	WP upside-down Ø 43 mm
Front Brake	Four-piston radial fixed caliper, brake disc
Rear Brake	Single-piston floating calliper, brake disc
Front Tire	110/70 x 17
Rear Tire	150/60 x 17
ABS	Bosch 9MB Two Channel ABS