12 SERVICE WORK ON THE CHASSIS 97
M00714-10
Main work
– Shift gear to neutral.
– In the area of the chain sliding guard, press the chain upward toward the swingarm and
determine chain tension
A
.
Info
The upper part of chain
B
must be taut.
Chain wear is not always even, so you should repeat this measurement at differ-
ent chain positions.
Chain tension 5… 7 mm (0.2… 0.28 in)
» If the chain tension does not meet the specification:
– Adjust the chain tension. (
p. 97)
– Remove the rear of the motorcycle from the lifting gear. ( p. 88)
12.13 Adjusting the chain tension
Warning
Danger of accidents Incorrect chain tension damages components and results in accidents.
If the chain is tensioned too much, the chain, engine sprocket, rear sprocket, transmission and rear wheel bearings wear more
quickly. Some components may break if overloaded.
If the chain is too loose, the chain may fall off the engine sprocket or the rear sprocket. As a result, the rear wheel locks or the
engine will be damaged.
– Check the chain tension regularly.
– Set the chain tension in accordance with the specification.
Preparatory work
– Raise the motorcycle with the rear lifting gear. ( p. 88)
To Next Page
Loading...
Need help?
General
