KTM 125 Duke 2017 User Manual

23 DECLARATIONS OF CONFORMITY 184
1 This device must not cause harmful interference.
2 This device must be able to absorb any received interference, including interference that potentially causes undesirable operation.
This equipment has been tested and complies with the limits for Class B digital devices, in accordance with article 15 of the FCC regu-
lations. These limits are designed to provide satisfactory protection against harmful interference in residential areas. Devices of this type
generate and use and also transmit radio frequencies. Therefore, if they are not installed and operated in accordance with the instructions,
they may cause harmful interference to radio reception. However, there is no guarantee that interference will not occur in certain cases of
application. Should this device cause harmful interference to radio or television reception, (check this by switching the device on and off),
you can potentially eliminate this interference as follows:
– Re-align the receiving antenna.
– Increase the distance between device and radio receiver.
– Connect the device and the radio receiver to separate electric circuits.
– Consult your dealer or a radio/TV technician.
Alterations and modifications not expressly approved by the relevant authority may result in the user being prohibited from operating the
equipment.

KTM 125 Duke 2017 Specifications

General

Displacement	124.7 cc
Bore x Stroke	58 mm x 47.2 mm
Compression Ratio	12.6:1
Power	15 hp (11 kW) @ 10, 000 rpm
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Rear Suspension	WP monoshock
Seat Height	830 mm
Ground Clearance	185 mm
Dry Weight	137 kg
Engine Type	Single cylinder, 4-stroke
Torque	12 Nm @ 8, 000 rpm
Frame	Steel trellis frame, powder coated
Front Suspension	WP upside-down Ø 43 mm
Front Brake	Four-piston radial fixed caliper, brake disc
Rear Brake	Single-piston floating calliper, brake disc
Front Tire	110/70 x 17
Rear Tire	150/60 x 17
ABS	Bosch 9MB Two Channel ABS