KTM 1290 Super Adventure S User Manual

TROUBLESHOOTING 22
299
Faults Possible cause Action
Malfunction indicator lamp
lights up
Error in the electronic fuel
injection
– Read out the fault memory using the
KTM diagnostics tool.
The ABS warning lamp lights
up
ABS fuse is blown – Change the fuses in the fuse box.
( p. 262)
Wheel speeds of front and rear
wheels differ greatly
– Stop, switch off the ignition, start
again.
Malfunction in ABS – Read out the fault memory using the
KTM diagnostics tool.
High oil consumption Engine oil level too high – Check the engine oil level. ( p. 277)
Engine oil too thin (low viscos-
ity)
– Change the engine oil and the oil filter,
clean the oil screens. ( p. 278)
12-V battery discharged A power consumer is connected
to the socket/ACC1.
– Disconnect the power consumer from
the socket/ACC1.
– Charge the 12-V battery. ( p. 253)
The hazard warning flasher is
switched on
– Switch off the hazard warning flasher.
– Charge the 12-V battery. ( p. 253)
The 12-V battery is not being
charged by the alternator
– Check the charging voltage.
Ignition was not switched off
when vehicle was parked
– Charge the 12-V battery. ( p. 253)

KTM 1290 Super Adventure S Specifications

General

Engine Type	2-cylinder, 4-stroke, V 75°
Displacement	1301 cc
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Dry Weight	220 kg
Front Suspension	WP Semi-active Suspension USD Ø 48 mm
Rear Suspension	WP Semi-active Suspension Monoshock
Traction Control	Motorcycle Traction Control (MTC)
Power	160 hp
Torque	138 Nm
Fuel Capacity	23 liters
Front Brakes	2 x Brembo 4-piston radial calipers, 320 mm discs
Rear Brakes	Brembo 2-piston caliper, 267 mm disc
ABS	Bosch 9ME Combined ABS
Wheelbase	1560 mm