15 ELECTRICAL SYSTEM
122
This battery charger is only suitable for lithium
iron phosphate batteries. Read the accompanying
KTM Power Parts instructions.
Info
Never remove cover
1
.
– Switch off the battery charger after charging and disconnect it
from the 12-V battery.
Finishing work
– Install the 12-V battery. ( p. 119)
– Mount the seat. ( p. 79)
15.4 Changing main fuse
Warning
Fire hazard Incorrect fuses overload the electrical system.
– Only use fuses with the required ampere value.
– Do not bypass or repair fuses.
Info
The main fuse protects all power consumers of the vehicle.
Preparatory work
(All EXC models)
– Press and hold the switch-off button while the engine is
idling until the engine stops.
(All XC‑W models)
– Press and hold the switch-off button while the engine is
idling until the engine stops.
– Remove the seat. ( p. 79)
S03495-10
Main work
–
Pull EFI control unit
1
upward off the rubber lugs
2
and
hang to the side.
S03496-10
–
Pull starter relay
3
from the holder.
To Next Page
Loading...
Need help?
General
