PREPARING FOR USE 8
41
8.6 Preparing the vehicle for riding on wet sand
M01129-01
– Check the radiator cap.
Value on the radiator cap 1.8 bar (26 psi)
» If the indicated value does not correspond to the setpoint
value:
Warning
Danger of scalding During motorcycle oper-
ation, the coolant gets very hot and is under
pressure.
– Do not open the radiator, the radiator hoses
or other cooling system components if the
engine or the cooling system are at operat-
ing temperature.
– Allow the cooling system and the engine to
cool down before you open the radiator, the
radiator hoses or other components of the
cooling system.
– In the event of scalding, rinse the area
affected immediately with lukewarm water.
– Change the radiator cap.
M01106-01
–
Mount the air filter rain cover.
Air filter rain cover (79006921000)
Info
Observe the KTM PowerParts fitting instructions.
600868-01
– Clean the chain.
Chain cleaner ( p. 168)
– Mount the steel sprocket.
– Grease the chain.
Universal oil spray ( p. 169)
– Clean the radiator fins.
– Straighten the bent radiator fins carefully.
Condition
Regular use in sand
– Change the piston every 10 operating hours.
To Next Page
Loading...
Need help?
General
