MAINTENANCE WORK ON CHASSIS AND ENGINE 48
– Mount the dust cap.
9.70Checking spoke tension
Warning
Danger of accidents Instable handling due to incorrect spoke tension.
– Ensure that the spoke tension is correct. (Your authorized KTM workshop will be pleased to help.)
Info
A loose spoke can cause wheel imbalance, which leads to more loose spokes in a short time.
If the spokes are too tight, they can break due to local overload.
Check the spoke tension regularly, especially on a new motorcycle.
700435-01
– Briefly strike each spoke with the blade of a screwdriver.
Info
The frequency of the tone depends on the spoke length and diameter.
If you hear different tone frequencies from spokes of the same length and
thickness, this is an indication that the spoke tension differs.
You should hear a high note.
» If the spoke tension differs:
–
Correct the spoke tension. x
– Check the spoke torque.
Guideline
Spoke nipple M3.5 3 Nm (2.2 lbf ft)
Torque wrench with various accessories in set (58429094000)
9.71Removing the seat
300633-10
– Open quick release and raise the rear of the seat.
– Pull back the seat and remove it.
9.72Mounting the seat
300634-10
– Hook the seat onto screw and lower the seat at the rear while pushing it forward.
Projection hooks into the fuel tank.
To Next Page
Loading...
Need help?
General
