MAINTENANCE WORK ON CHASSIS AND ENGINE 51
9.77Refilling coolant x
Warning
Danger of poisoning Coolants are poisonous and a health hazard.
– Avoid contact between coolants and skin, eyes and clothing. If fuel gets into your eyes, rinse immediately with water and
contact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor
immediately. Change clothes that have come into contact with coolants. Keep coolants out of the reach of children.
700447-01
– Make sure that the screw is tightened.
– Stand the vehicle upright.
– Add coolant to level .
Guideline
Level above the radiator fins 10 mm (0.39 in)
Coolant 0.55 l (0.58 qt.) Coolant ( p. 68)
Coolant (mixed ready to use) ( p. 68)
– Mount the radiator cap.
– Make a short test ride.
– Check the coolant level. ( p. 50)
9.78Glass fiber yarn filling of main silencer
The main silencer is filled with glass fiber yarn.
Over a period, the fibers of the insulating material vanish into the air, and the silencer "burns out".
Not only is the noise level higher, the performance characteristic changes.
9.79Removing main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
– Allow the exhaust system to cool down. Do not touch hot components.
700442-01
– Remove screw .
– Pull the main silencer off of the manifold at the rubber sleeve .
9.80Installing the main silencer
700444-01
– Mount the main silencer with the rubber sleeve .
– Position the wide collar bushing and the narrow collar bushing .
To Next Page
Need help?
General
