KTM 65 SX 2009 User Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE 55
700458-01
– Place a cloth beneath the carburetor to soak up emerging fuel.
– Remove plug .
– Completely drain the fuel.
– Mount and tighten the plug.
9.89Checking gear oil level
Info
The gear oil level must be checked when the engine is cold.
– Stand the motorcycle upright on a horizontal surface.
300661-10
– Remove gear oil level check screw . Stand the vehicle upright.
– Check the gear oil level.
A small amount of gear oil should flow out of the hole.
» If no gear oil flows out:
–
Add gear oil. x ( p. 56)
– Mount and tighten the gear oil level check screw.
Guideline
Screw, gear oil level check M6 6 Nm (4.4 lbf ft)
9.90Changing the gear oil x
–
Drain the gear oil. x ( p. 55)
–
Fill up with gear oil. x ( p. 56)
9.91Draining the gear oil x
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
– Wear suitable protective clothing and protective gloves. If you get scalded, immediately flush the affected areas with luke-
warm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the gear oil only when the engine is warm.
– Stand the motorcycle on its side stand on a horizontal surface.
300659-10
– Place a suitable container under the engine.
– Remove the gear oil drain plug with magnet .
– Completely drain the gear oil.
– Thoroughly clean gear oil drain plug with magnet.
– Clean the sealing area on the engine.
– Mount the gear oil drain plug with magnet and the seal ring and tighten it.
Guideline
Oil drain plug with magnet M12x1.5 20 Nm
(14.8 lbf ft)

KTM 65 SX 2009 Specifications

General

Brand	KTM
Model	65 SX 2009
Category	Motorcycle
Language	English