MAINTENANCE WORK ON CHASSIS AND ENGINE 52
700442-10
– Mount and tighten screw .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
9.81Removing the glass fiber yarn filling of the main silencer x
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
– Allow the exhaust system to cool down. Do not touch hot components.
– Remove the main silencer. ( p. 51)
700443-01
– Remove screws of locking cap . Remove locking cap and outer tube .
– Pull the glass fiber yarn filling from the inner tube.
– Clean the parts that are to be reinstalled.
9.82Installing the glass fiber yarn filling of the main silencer x
700443-10
– Slide the glass fiber yarn filling over the inner tube.
– Slide the outer tube over the glass fiber yarn filling.
– Insert the locking cap into the outer tube. Mount the screws with toothed
wheels and tighten.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
– Install the main silencer. ( p. 51)
9.83Removing the air filter x
Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
– Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
– Remove the seat. ( p. 48)
700441-01
– Unhook the air filter holder and swing it to the side. Remove the air filter with
the air filter support.
– Remove the air filter from the air filter support.
To Next Page
Loading...
Need help?
General
