Safety
19
Maintenance
Comply with the service and maintenance intervals given in the
instructions
Comply with the intervals for service and maintenance as given in the
instructions.
By complying with the maintenance intervals, you ensure that the
machine will operate without malfunctions and provide maximum
protection for the environment.
An incorrectly maintained machine is a danger to the environment.
Always use original spare parts on the machine
Always use original spare parts.
Original spare parts should be used for safety reasons
The manufacturer assumes no warranty responsibility in cases where
non-original spare parts are used.
High risk when performing service and maintenance work
When performing service or maintenance work, there is a higher risk
of injury.
Paying full attention to the aforementioned point ensures your safety
and that of others.
Failure to pay attention to the aforementioned point may result in
serious injuries.
Therefore, when you perform maintenance work:
• Disconnect the P.T.O. shaft.
• Depressurize the hydraulic system.
• Stop or disconnect the tractor.
• Check that the machine is parked safely; support it if necessary.
• Do not use parts of the machine to climb onto it; the correct
climbing devices must be used.
• Make sure that the machine can not start rolling.
Disconnect the power source when working on the electrical
systems
Always disconnect the power source before you start working on the
electrical system.
This will prevent short circuits and damage to the electric circuit.
There is a risk of burns and other serious injuries if the electrical
systems short circuit.
Replacing the hydraulic hoses
Replace the hydraulic hoses at least once every 6 years.
Hydraulic hoses also wear without any visible damage.
Defective hydraulic hoses may cause serious injury.
95-009
To Next Page
Loading...
Need help?
General
