Kubota DMC 8028 - P.T.O. shaft

Troubleshooting
211
P.T.O. shaft
•
1
Problems with stripes are more likely to occur when mowing
short, strong, spring crops in less than ideal weather conditions.
Always begin by checking that the blades on the cutting discs are
sharp.
•
2
May only be carried out by authorized service personnel.
•
3
Extra equipment - Page 206.
Conditioning too
weak
Too little roller pressure Adjust the roller pressure 75
Driving speed is too high Reduce driving speed
The V-belts at the roller are not
tightened sufficiently
Check the V-belts
151
The roller V-belts are worn Replace the V-belts 195
Blockage of the
flow of crop
through the
machine
The V-belts at the roller are not
tightened sufficiently
Check the V-belts
151
The roller V-belts are worn Replace the V-belts
195
The cutterbar gets
abnormally warm
Too much oil in the cutterbar Inspect the oil level in the cutterbar 115
Wrong oil type Change to the correct oil type 216
Fault Possible cause Solution Page
Fault Possible cause Solution Page
The friction clutch
on the P.T.O. shaft
becomes
abnormally warm
The RPM on the P.T.O. shaft is too low Check RPM 32
The friction discs in the coupling are
worn
Check the friction discs in the
coupling
153
Replace the friction discs in the clutch 199
Insufficient
transferal of
power/torque to
the machine
The friction discs in the coupling are
worn
Check the friction discs in the
coupling
153
Replace the friction discs in the clutch
199