Assembly - attachment
44
Attachment of the
tractor
8028 - 8032 only
In order to connect machines in compliance with ISO 6489-3, the
following shall be observed:
• (A) Distance between the P.T.O. shaft and the connection point on
the drawbar tongue: approx. 356 mm (14”).
• (A) Height between the P.T.O. shaft and the connection point on
the drawbar tongue: approx. 203 - 305 mm (8 - 12”).
• (C) Height between the ground and the drawbar tongue: approx.
400 mm (15
3
/
4
”).
\ WARNING
Connecting the machine
When connecting the machine there is an increased risk of injury.
Attention to the task will ensure your safety and that of others.
Failure to follow the safety instructions may result in serious
injuries.
Lock the tractor's lift arms
Lock the tractor's lift arms at the correct height.
If the lift arms are at the correct height,it will prevent damage to the
PTO shaft and injury to persons in the vicinity.
Lowering or raising the lift arms can lead to injury and can damage
the PTO shaft.
Secure the attachment with the locking pin
The attachment must be secured to the machine with the locking
pin.
The locking pin secures the machine against becoming detached
from the tractor.
Attachment without the locking pin can result in the machine
becoming detached, leading to serious or fatal injury.
Therefore, when connecting the machine you should be sure that:
• The machine cannot become detached from the tractor.
• The coupling is secured with the locking pin.
• The tractor PTO shaft should be 1 3/8”, with 6 or 21 splines and
able to run at 540 or 1000 rpm.
To Next Page
Loading...
Need help?
General
