Assembly - attachment
54
Initial startup of
machine
Check that the machine's guards are in place.
Check that the side guard on the cutting unit is folded out and
correctly positioned.
Check that the mechanical safety valve is open.
Carefully connect the tractor's P.T.O. shaft.
Carefully increase the speed on the P.T.O. shaft to 1000 RPM.
→ »Number of revolutions on the P.T.O. outlet« Page 38
Check that the machine runs smoothly without any vibrations.
Reduce the P.T.O. shaft to idle speed.
Activate all the hydraulic functions of the machine, one by one.
Disconnect the tractor's P.T.O. shaft.
\ WARNING
The initial test drive of the machine is important
When the machine is connected to the tractor for the first time it
must be test driven.
Attention to the task will ensure your safety and that of others.
Failure to follow the safety instructions may result in serious
injuries.
Do not remove the protective guards
Check that all protective guards are in place before use.
This ensures that the machine will offer maximum protection to the
operator from the cutting blades.
If the safety guards are removed or not used, it may result in
serious injuries and accidents.
The guard for the cutting unit must be correctly positioned
before start up
The guard for the cutting unit must be folded down and correctly
positioned before the machine is started.
This ensures that the machine will give maximum protection to the
operator from thrown objects.
Thrown objects may cause serious injuries and accidents.
To Next Page
Loading...
Need help?
General
