26 OPERATING THE MOWER
Reference
• Set the position for a recommended ground clearance
of
19
mm
(3/4 in.).
(Figure shows a setting position
of
cutting height
50
or
55
mm
(2.0" or 2.25"))
1
BDABBSAP030A
(Ref.) Ground
Cutting height
Position
of
bolts
clearance
inch (mm) between
rollers
and the ground
1"
(25)
*1
6
mm
(0.2 in.)
1.25" (32)
*2
1
12.4
mm
(0.5 in.)
1.5" (38)
19.0
mm
(0.7 in.)
1.75"(44)
25.4
mm
(1.0 in.)
2.0" (50)
2
19.0
mm
(0.7 in.)
2.25" (58)
25.4
mm
(1.0 in.)
2.5" (64)
19.0
mm
(0.7 in.)
2.75"
(70)
25.4
mm
(1.0 in.)
3.0" (76) *3
3 (31.8 mm) (1.3 in.)
3.5" (89) *3 (44.6 mm) (1.8 in.)
4.0" (102) *3 (57.4 mm) (2.3 in.)
*1. Cutting height
1"
is
a ground clearance
of
6
mm.
*2.
Cutting height 1.25"
is
a ground clearance
of
12.4
mm.
*3.
For cutting heights above 3.0". The anti-scalp rollers
will still
be
effective against scalping.
OPERATING
THE
MOWER
NOTE:
• This machine
is
equipped with the KRA (KUBOTA
Reverse Awareness) system.
This feature shuts down the engine if the operator
attempts reverse
travel while any PTO driven
implement
is
engaged. The purpose
of
the KRA
system
is
to increase operator awareness
of
the risk
of
back-over accidents. The KRA system incorporates
an
override switch
on
the dash that allows the operator to
override the system and keep the
PTO engaged
during reverse
travel. KUBOTA strongly recommends
against overriding the KRA system, but if the operator
deems it absolutely necessary and safe to do so,
he
may activate the override switch. The override switch
light flashes while activated as a reminder to the
operator that the
PTO
(Le.
mower, grass catcher,
snowblower, etc.) remains engaged during reverse
travel. The operator should return the KRA system to
normal operating mode
as
soon
as
possible by
momentarily disengaging the PTO.
• KRA system Normal Operating Mode
1.
Start the engine.
2.
Set the throttle lever to the "FAST" position.
(1) Throttle lever
~:
"FAST" position
--:
"SLOW" pOSition
3.
Push down the PTO lever to the "ENGAGED" position.
To Next Page
Loading...
Need help?
General
