EasyManuals Logo

Kubota GR2100 User Manual

Kubota GR2100
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
.Replacing
Transmission
Oil
Filter
Cartridge
'
A CAUTION
To avoid personal injury:
Be
sure to stop the engine and remove the key
before changing the oil filter cartridge.
Allow transmission case to cool down
sufficiently; oil can
be
hot and may cause
burns.
1.
The oil filter cartridge must
be
changed every 200
service hours.
1 BDAHADAP059A
(1)
Cover
1 BDAHADAP073A
PERIODIC SERVICE
59
1 BDABARAP003D
(1)
Transmission
oilfilter
cartridge
2.
Remove rear cover.
3.
Remove the oil filter cartridge by using the filter
wrench.
4.
Lightly tighten the screw (A) by using a screwdriver.
5.
Apply a slight coat of oil onto the cartridge gasket.
6.
To install the new cartridge, screw it
in
by hand. Over
tightening may cause deformation
of
the rubber
gasket.
7.
After the new cartridge has been replaced, the
transmission fluid
level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
8.
Assemble the rear cover.
IMPORTANT:
To prevent serious damage or premature failure to the
hydraulic system, the replacement filter must be a
highly efficient,
10.urn
filter. Use only a genuine
KUBOTA filter or its equivalent.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota GR2100 and is the answer not in the manual?

Kubota GR2100 Specifications

General IconGeneral
Horsepower21 HP
TransmissionHydrostatic
Cutting Width48 inches
Drive2WD
Engine TypeDiesel
Turning RadiusZero turn

Related product manuals