99PERIODIC SERVICE
EVERY 400 HOURS
BChanging Transmission Fluid / Replacing
Hydraulic Oil Filter
To avoid personal injury:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the drain plugs at the bottom of the
transmission case and drain the oil completely into the
oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil filter.
4. Put a film of clean transmission oil on the rubber seal
of the new filter.
5. Quickly tighten the filter until it contacts the mounting
surface, then tighten it by hand an additional 1/2 turn
only.
6. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
(1) Drain plugs
(1) Drain plug
(1) Drain plugs
(1) Hydraulic oil filter
Oil
Capacity
L3240, L3540 42 L (11.1 U.S.gals.)
L3940, L4240, L4740 43 L (11.4 U.S.gals.)
L5040, L5240, L5740 45 L (11.9 U.S.gals.)
To Next Page
Loading...
Need help?
General
