Operation
74
General
The following work steps are described in this section:
• »Crop processing«
• »Twin rotor operation«
• »Single rotor operation with hydraulic single lift [+]«
• »Adjusting the swath width«
• »Driving on headlands«
Suitable working speeds
Select a driving speed (approx. 4 to 12 km/h) at which the crop is
picked up cleanly and completely. The working speed depends on the
machine settings and the particular crop.
Swath width
The swath width depends on working width, working speed, tine lift
settings and transverse rotor pitch as well as crop condition.
The swath width is between approx. 1.50 m (4.9 ft) and approx. 2.00 m
(6.6 ft).
Crop processing
The following methods of crop processing are possible with this
machine:
• »Central swath with two rotors«, page 76.
• »Single rotor operation with hydraulic single lift [+]«, page 77.
• »Single swath with right rotor in headland position«, page 77.
• »Single swath with left rotor in headland position«, page 77.
• »Single swath with right rotor in transport position«, page 79.
• »Single swath with left rotor in transport position«, page 79.
To Next Page
Loading...
Need help?
General
