Maintenance
94
Lubrication points
for grease
Working with a grease gun
Before applying the grease gun
• Clean grease fittings on the machine and gun fittings on the grease
gun.
Lubricate the bearings with one or two presses of the grease gun. If
you feel resistance at the second press, do not press a second time.
Too much grease will force the bearings apart. This could allow dust
and dirt to enter the bearing, resulting in premature wear.
Lubrication points are marked with an information label. If any labels
are illegible or have been lost, it is possible to order new labels as
replacement parts and affix them to the implement.
Lubricate the places listed in the illustration as follows:
• after 50 hours of operation.
• before and after the season.
• each time after cleaning with a high-pressure cleaner.
.
Attachment carrier and
steering
Bearing housing
4x lift arm bearings
Transport chassis
4x tandem axles [+]
Steering rod
Steering
2x lifting cylinder, lower
side
Rotor chassis
To Next Page
Loading...
Need help?
General
