Cleaning and care
84
Cleaning and care
Safety
The following applies to all cleaning and care work:
\ WARNING
Observe the safety information
Disregard for safety information can lead to serious or fatal injury.
See chapter »Safety«, page 8.
Securing the machine
• Switch off the PTO shaft drive.
• Depressurise the hydraulic system.
• Whenever possible, uncouple the tractor.
• Place all controls in neutral or park.
• Set tractor parking brake.
• Switch off the tractor and remove the ignition key.
• Ensure the machine is standing on firm, secure and level
ground, and provide additional support, if necessary.
• Secure the machine against rolling away (use wheel chocks).
Only if these regulations are observed can safe working be
ensured during care and maintenance work. Unsecured or
non-supported machines can cause accidents.
No persons in the working area
Ensure that no persons, especially children, are present in the
slewing and working area of the machine. Persons could be
caught by the machine within this area. This could result in fatal
injury.
Do not clean bearings or hydraulic parts with high pressure
cleaners
Do not clean bearings or hydraulic parts with high pressure
cleaners. The high-pressure cleaner removes the grease film from
the bare metal surfaces. Metal surfaces treated in this way can
corrode. After each cleaning procedure, lubricate the bearing
points and grease uncoated parts.
Clean the bearings and hydraulic parts with care
Exercise caution when cleaning with a high-pressure cleaner.
Bearings, seals and pipe unions are not waterproof. In order to
prevent damage to the machine, the bearings, seals and pipe
unions must not be exposed to direct contact with the high
pressure water jet.
To Next Page
Loading...
Need help?
General
