Maintenance
95
Lubricating the
PTO shafts
The PTO shaft manufacturer's own operator’s manual is included with
each PTO shaft. This includes detailed information on the relevant
version of the PTO shaft.
Lubricate the single joints and their couplings as follows:
• after 60 hours of operation.
• before and after the season.
• each time after cleaning with a high-pressure cleaner.
Grease the profile section tubes:
• after 60 hours of operation.
• before and after the season.
• each time after cleaning with a high-pressure cleaner.
Lubricate the guard as follows:
• after 250 hours of operation.
• before and after the season.
• each time after cleaning with a high-pressure cleaner.
PTO shaft for rotors
PTO shaft for the main
drive
\ WARNING
Check the guard components
Check all guard components of the PTO shafts for wear or
damage (visual inspection). Replace any defective guard
components. An unguarded PTO shaft or damaged guard
components can cause very serious injuries during operation.
To lubricate the PTO shaft, remove it on the coupling side and
slide the profile section tubes together.
60 h
To Next Page
Loading...
Need help?
General
