PERIODIC SERVICE78
EVERY 400 HOURS
BChanging Front Knuckle Case Oil
1. Park the vehicle on a firm, flat and level surface.
2. Remove the tire.
3. To drain the used oil, remove the drain and filling plugs
at the left hand knuckle case and drain the oil
completely into the oil pan.
4. After draining, reinstall the drain plug.
5. Fill with the new prescribed oil up to the filling port
level.
(See the first table of "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
6. After filling, reinstall the filling plug.
7. Use the same procedure to change the right hand
knuckle case oil.
8. Properly dispose of used oil.
BChanging Transmission Fluid
To avoid serious injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a level surface.
2. Raise the cargo bed and mount the safety support.
3. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
4. After draining, reinstall the drain plug.
5. Fill with the new prescribed oil up to the upper cross
hatched area on the dipstick.
(See the first table of "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
6. After running the engine for a few minutes, stop the
engine and check the oil level again; add oil to
prescribed level.
7. Properly dispose of used oil.
Oil capacity (one side) Ref. 0.25 L (0.26 U.S.qts.)
(1) Drain plug
(2) Filling plug
Oil Capacity 7.0 L (1.8 U.S.gals.)
(1) Oil inlet
(2) Dipstick
(A) Oil level is acceptable within this range.
To Next Page
Loading...
Need help?
General
