23OPERATING THE VEHICLE
BFuel Gauge
Park the vehicle on a flat place.
When the key switch is "ON", the fuel gauge indicates the
fuel level.
Be careful not to empty the fuel tank. Otherwise air may
enter the fuel system.
Should this happen, the system should be bled. (See
"Bleeding Fuel System" in "SERVICE AS REQUIRED" in
"PERIODIC SERVICE" section.)
BCoolant Temperature Gauge
To avoid serious injury:
A Do not remove radiator cap until coolant and
engine temperature has cooled. Then loosen
cap slightly to the stop to relieve any pressure
before removing cap completely.
1. With the key switch "ON" the coolant temperature
gauge indicates the temperature of the coolant.
2. If the engine is overheated, the warning lamp will come
on and the buzzer will sound. Check the vehicle by
referring to "TROUBLESHOOTING" section.
A If the engine overheat and VHT overheat occur
together, do not stop the engine. When it is safe to do
so, remove the engine load and keep the engine idling
to allow cool down to occur.
After the warning lamps go off, wait for 5 minutes, and
stop the engine.
See "TROUBLESHOOTING" section.
(1) Fuel gauge
(2) Fuel level warning lamp
(1) Coolant temperature gauge
(2) Overheat warning lamp
To Next Page
Loading...
Need help?
General
