OPERATING THE VEHICLE22
BSpeed Control Pedal
Use the speed control pedal when traveling. Push down
on it for higher speed.
STOPPING
BStopping
1. Release the speed control pedal.
2. Step on the brake pedal.
3. After the vehicle has stopped, put the range gear shift
lever in neutral, and set the parking brake.
CHECK DURING DRIVING
BImmediately Stop the Engine if:
A The engine suddenly slows down or accelerates.
A Unusual noises suddenly occur.
A Exhaust fumes suddenly become very dark.
While driving, check the following items to see that all the
parts are functioning normally.
BEasy Checker(TM)
If the warning lamps in the Easy Checker(TM) come on
during operation, immediately stop the engine, and find
the cause as shown below.
Never operate the vehicle with an Easy Checker(TM)
lamp on.
Engine oil pressure
If the oil pressure in the engine goes below the
prescribed level, the warning lamp in the Easy
Checker(TM) will come on.
If this should happen during operation, and it does not
go off when the engine is accelerated, check level of
engine oil.
(See "Checking Engine Oil Level" in "DAILY CHECK"
in "PERIODIC SERVICE" section.)
Electrical charge
If the alternator is not charging the battery, the Easy
Checker(TM) will come on.
If this should happen during operation, check the
electrical charging system or consult your local
KUBOTA Dealer.
Low brake fluid level
If the brake fluid goes below the prescribed level, the
warning lamp in the Easy Checker(TM) will come on.
If this should happen during operation, check to see
that there is no oil leak in the brake system, and then
add Dot3 brake fluid.
(See "Checking Brake Fluid Level" in "DAILY CHECK"
in "PERIODIC SERVICE" section.)
VHT oil temperature
If the VHT oil is overheated, the warning lamp will
come on and the buzzer will sound.
Check the vehicle by referring to
"TROUBLESHOOTING" section.
Parking brake
If the parking brake indicator is on during operation,
release the parking brake lever immediately.
The parking brake indicator in the Easy Checker(TM)
comes on if the parking brake is applied.
Seat belt [RTV-X1120D only]
With the key switch "ON", when the operator or
passenger does not fasten the seat belt, seat belt
warning lamp comes on.
(1) Speed control pedal (A) "INCREASE"
(1) Easy Checker(TM)
(2) Coolant temperature gauge
(3) Fuel gauge
To Next Page
Loading...
Need help?
General
