23
3. Pull the lock lever all the way back. (lock
position).
4. Insert the key into the starter switch
and turn it to the "RUN" position, and
the glow lamp indicator will light up
while the engine is preheated, and will
go out automatically after preheating is
fi nished.
(1) Starter Switch (A) “STOP”
(B) “RUN”
(C) “START”
5. Turn the key to “START” position and
release after the engine has started; it
will automatically return to the “RUN”
position.
6. Check if all warning lamps have gone
out. Should a warning lamp still be lit up,
stop the engine then remove the key and
check for the cause.
Display Selector Switch
Press the display selector switch, and the
electronic meter’s LCD display will change
from one indication mode to the other.
Change the two-mode display according to
your jobs.
(1) Display selector switch
(2) LCD display
(1) Fuel gauge (A) ”INDICATION MODE 1”
(2) Water temperature
gauge
(3) Oil lamp
(4) Hour meter
(5) Charge lamp
(6) Glow lamp
NOTE:
With the starter key at the ”STOP”
position, press the electronic meter’s
display selector switch or the working
light switch, and the LCD display shows
the hour meter, fuel gauge and water
temperature gauge for 10 seconds.
To Next Page
Loading...
Need help?
General
