64
ANNUAL SERVICING
Electrical Wiring and Fuses
Check the terminals periodically for proper
connections. Loose wiring or damaged
cables can cause improper functioning or
short circuiting of the electrical system. Check
wiring and replace damaged components
immediately. If a fuse blows out soon after
having been replaced, contact your nearest
KUBOTA dealer. Never use a fuse other than
specifi ed.
BIENNIAL SERVICING
3
CAUTION
To avoid personal injury:
Do not loosen the radiator
cap before the radiator has
cooled down suffi ciently. Then
only loosen the cap and allow
enough time for the pressure in
the system to be released. Now
remove the cap completely.
Replacement of Radiator Hoses
Replace radiator hoses and hose clamps
ever two years. If the hoses are swollen, hard
or cracked, they must be replaced earlier.
(1) Radiator hoses
(2) Hose clamps
Changing Radiator Coolant
(In case of long-life coolant fl uid)
Stop the engine then remove the key and
wait until it has cooled down completely.
1. Open the drain plug on the bottom of the
radiator and drain coolant completely.
2. To clean, rinse the radiator with water.
3. Close the drain plug and fi ll the radiator
and the reserve tank with coolant fl uid.
Let the engine idle for about 5 min., stop
the engine and remove the key then
check the coolant level.
4. The machine has been shipped fi lled
with 50% anti-freeze solution.
(1) Drain plug
(1) Radiator cap
(1) Reserve tank (A) “FULL”
(B) “LOW”
To Next Page
Loading...
Need help?
General
