68
Special Information when Using
Rubber Tracks
1. When turning, make a slow swing turn.
Avoid spin turns to lessen lug wear and
entry of dirt.
2. The relief valve may be activated if too
much dirt and sand clog the tracks. In
this case move the machine for a short
distance straight backwards to let the
earth and sand fall off, then a turn can be
made.
3. Avoid using rubber track on riverbeds,
stony underground, ferro-concrete and
on iron plates. The rubber can damage as
well as increase wear on the tracks.
EXCHANGE OF BUCKET TEETH
AND SIDE CUTTERS [JPN BUCKET
VERSION]
Bucket Tooth Replacement
3
CAUTION
To avoid personal injury:
Wear eye protection when
changing the tooth points.
1. Position a screw driver or similar tool
above the lock pin and knock out the pin
and rubber plug with a hammer.
2. Remove the worn point from the adapter
by hitting it with a hammer.
3. Clean the adapter.
To Next Page
Loading...
Need help?
General
