Paper Handling
1-39
Selecting the Output Stack
The following procedure allows you to select whether printouts will be
received by the top tray or to the rear tray. If an option sorter is installed, it
can also be selected using the manner described below.
1
Press the MENU key.
2
Press the or key repeatedly until Paper Handling > appears.
3
Press the > key.
4
Press the or key repeatedly until >Stack Select appears.
5
Press the ENTER key. A blinking question mark (?) appears.
6
Press the or key to display the desired destination. The output
tray changes as shown below.
Top tray FaceDn (Printer’s top tray) [Default]
RearTray FaceUp (Printer’s rear tray) [Option rear tray required]
Sorter FaceDn [Option sorter required]
7
When the desired paper source displayed, press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
Paper Handling >
>Stack Select
Top tray FaceDn
>Stack Select
?Top tray FaceDn
To Next Page
Loading...
Need help?
General