Name: Kyocera FS-1320D
Brand: Kyocera
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2LY/2LZ

1-6-2

(1) Downloading the firmware from the memory card

To download data written in a memory card (CompactFlash) to the printer, proceed as explained in this section.

CAUTION

Downloading firmware takes several minutes. Do not turn power off during downloading. If downloading is interrupted by

an accidental power failure, etc., the control PWB may have to be replaced.

Do not download the system firmware and engine firmware at one time. Store the either firmware in a memory card and

download one by one.

Procedure

1. Turn printer power off.

2. Open the rear cover.

Figure 1-6-2

3. Remove two screws and then remove the

optional interface slot cover.

4. Insert the memory card into the memory

card slot.

Figure 1-6-3

Rear cover

Screw

Optional interface

slot cover

Screw

Memory card

Memory card slot

Questions and Answers:

Need help?

Do you have a question about the Kyocera FS-1320D and is the answer not in the manual?

Kyocera FS-1320D Specifications

General

Print Technology	Laser
Paper Input Capacity	250 sheets
Connectivity	USB 2.0
Memory	32 MB
Warm-up Time	15 seconds or less
Multi-purpose Tray Capacity	50 sheets
Print Speed	20 ppm
Resolution	1200 dpi
Paper Size (Main Tray)	A4, Letter, Legal
Print Media Sizes (Non-standard)	70 x 148 mm to 216 x 356 mm