Handling Paper
1-4 ADVANCED OPERATION GUIDE
Selecting the Right Paper
This section describes the guidelines for selecting paper.
Condition
Avoid using paper that is bent at the edges, curled, dirty, torn, embossed,
or contaminated with lint, clay, or paper shreds.
Use of paper in these conditions can lead to illegible printing and paper
jams, and can shorten the life of the machine. In particular, avoid using
paper with a surface coating or other surface treatment. Paper should have
as smooth and even a surface as possible.
Composition
Do not use paper that has been coated or surface-treated and contains
plastic or carbon. The heat of fusing can cause such paper to give off
harmful fumes.
Bond paper should contain at least 80% pulp. Not more than 20% of the
total paper content should consist of cotton or other fibers.
Paper Sizes
Cassettes and the MP Tray are available for the paper sizes listed in the
table below. The dimensional tolerances are ±0.7mm for the length and
width. The angle at the corners must be 90° ±0.2°.
MP tray Size
Cassette or
MP tray
Size
Envelope Monarch 3
7/8 × 7 1/2 inches Legal 8 1/2 × 14 inches
Envelope #10 4
1/8 × 9 1/2 inches Letter 8 1/2 × 11 inches
ISO A6 105 × 148mm ISO A4 210 × 297mm
Envelope DL 110 × 220mm ISO A5 148 × 210mm
Envelope #9 3
7/8 × 8 7/8 inches ISO A6 105 × 148mm
(FS-2000D: MP tray
only)
Envelope #6 3
5/8 × 6 1/2 inches Envelope C5 162 × 229mm
JIS B6 128 × 182mm ISO B5 176 × 250mm
Statement 5
1/2 × 8 1/2 inches JIS B5 182 × 257mm
Hagaki 100 × 148mm Executive 7
1/4 × 10 1/2 inches
Ofuku-Hagaki 148 × 200mm Oficio II 8
1/2 × 13 inches
Youkei 2 114 × 162mm Folio 210 × 330mm
Youkei 4 105 × 235mm 16 kai 197 × 273mm
To Next Page
Loading...
Need help?
General
Weight and Dimensions
