Page 3-123
Configuration Tool
Quick Setup will discover printers or scanners over either IPX or IP as long as the protocol is installed on the
Windows machine that is running Quick Setup (e.g., if only IPX is installed, then Quick Setup will find and
display only IPX printers. In this case, since this scanner does not support the IPX protocol, it will not be
displayed.)
• If a desired scanner is not displayed on the list…
If the scanner that you want to set-up does not appear in the list, an alternate method for connecting is to
enter its Ethernet address in the field provided. (The scanner’s Ethernet address is listed on the label that is
attached near the connector on the Scanner Interface Card.) If the scanner is not on the local segment of
your network, then you must also have a correctly configured the Default Gateway address, and the network
router(s) must be configured to forward IP broadcasts.
If the scanner cannot be found by Quick Setup, (e.g. IP broadcasts are not being forwarded), then register
the IP address in the scanner itself and use a Web browser or AdminManager for setup. In a Web browser,
IP broadcasts are not necessary since the IP address is entered directly. In AdminManager, you can search
for the scanner on a specific network. Refer to “Section 2 Making Settings from a Web Browser” for more
information on connecting with a Web browser.
To Next Page
Loading...
Need help?
General
