Kyocera KM-1650 User Manual

Page 1-27
Using the Scanner Function
3 . To select the Continuous Sending function as the default and, thereby, enable multiple scanning
operations at the same settings, select “On”. To have the touch panel return to the default scanner
settings after each scanning operation, select “Off”. Touch the “Close” key to register the change to that
setting.
* The factory default setting for inch specification scanners is “Off” while for metric specification
scanners it is “On”.
<Switching between standard transmission and Continuous Sending >
1 . Access the Scan to PC or Send E-mail screen, as appropriate, (“Ready to scan.” is displayed). The
following explains a scanning procedure using the Send to PC function.
Refer to “(3) Scanning under the Scan to PC and Send E-mail functions” on page 3-1 of the Set-Up
Edition of your Operation Guide for the procedure on accessing the Scan to PC and Send E-mail
screens.

Kyocera KM-1650 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Max Resolution	600 x 600 dpi
Paper Capacity	300 sheets
Memory	32 MB
Functions	Print, Copy, Scan
Type	Monochrome
Grayscale Half-Tones	256 levels
Max Document Enlargement	200%
Max Document Reduction	50%
Output Trays Capacity	250 sheets
Monthly Duty Cycle	15, 000 pages
Scan Type	Flatbed
First Copy Out Time B/W	5.9 seconds
Supported Media Type	Plain paper
Max Media Capacity	1, 300 sheets
Interface	USB 2.0
Original Size	A3 (11.7 in x 16.5 in) (max)