Copying Functions
4-22 OPERATION GUIDE
The procedure for using two-sided/duplex copying is explained below.
1 Place the originals on the platen.
NOTE: The underside Rotate Copy can also be set in
the System Menu. (Refer to 2-Sided Copy Reverse
Side Rotation Setting on page 4-5.)
The value set in the System Menu will inherit the value
that is set at the time when the copy is made.
2 Press [2-sided], select the type of original, and
select , or to light up the
corresponding display.
3 Enter the number of sets of copies using the
numeric keys.
4 Press the Start key to start scanning.
If the originals have been set in the optional
document processor, copying starts automatically.
If the original has been set on the platen, a
message prompting replacement of the original is
displayed. In this case, proceed to the next step.
5 Replace the original and press the Start key
Scanning of the original is performed.
6 After scanning all originals, press the OK key to
start copying.
2-Sided Copy Reverse Side Rotation Setting
Follow the procedure below to change the rotation setting for the reverse side when making 2-Sided copies.
1 Press the 2-sided key for 3 seconds.
The System Menu for the reverse side setting of 2-
Sided Copies will be displayed.
2 Press or to select Rotation On in the case
where the reverse side is to be rotated or
Rotation Off when it isn't to be rotated, and then
press the OK key.
The display will blink and the copier will return to
the state where copying can be continued.
To Next Page
Loading...
Need help?
General
