System Menu
OPERATION GUIDE 5-21
5
2 Press or to select select 51.Auto Sleep,
and then press the OK key.
3 Press or to select On in the case when the
transition to Auto Sleep is to be made or Off when
it is not, and then press the OK key.
The display will return to that of Step 2.
NOTE: If the Auto Sleep function interferes with your
copy operations, disable the function. Before disabling
the Auto Sleep function, you may want to try
lengthening the amount of time before the Auto Sleep
function engages.
Auto Clear Time
Set the time interval to automatically return the copier to Ready to copy. state when copying is finished.
1 Display the System Menu. (Refer to System Menu
Operation Procedures on page 5-7.)
2 Press or to select select
52.AutoClearTime, and then press the OK key.
3 Press or to select a time interval from 10 to
270 (seconds).
NOTE: Set the time interval to a longer length of time
in the case where the copier is used often and to a
shorter time interval when it is used infrequently.
This can be set when the Auto Clear setting has been
set to On. (Refer to Auto Clear Setting on page 5-20.)
4 Press the OK key.
The display will return to that of Step 2.
Low Power Mode Transition Time
Set the time interval from the time operations end to the automatic engagement of the Low Power Mode.
1 Display the System Menu. (Refer to System Menu
Operation Procedures on page 5-7.)
To Next Page
Loading...
Need help?
General
