Copying Functions
OPERATION GUIDE 4-25
4
Program Function
After registering sets of frequently used functions as a single program, you can simply press the program
number as needed to recall those functions. You can also name the programs for easy identification when
recalling.
Registering Programs
Use the procedure below to register a program.
The following procedure is an example of registering the copying function.
1 Set the Copy Mode to be registered.
2 Press the Program key for 3 seconds.
3 Enter the program number (0 to 9) using the
numeric keys and press the key for 3 seconds.
The display of the number entered will blink 2 times
and the program will be registered.
NOTE: If the same number as a program already
registered is input, the prior program is overwritten.
Recalling Programs
Use the procedure below to recall a registered program.
1 Press the Program key.
2 Press or to select the number of the
program to be used, and press the OK key.
NOTE: You can also select the program number using
a numeric key.
3 Place the originals and press the Start key.
Copying starts with the settings that were
registered.
To Next Page
Loading...
Need help?
General
