42
Skip Segment
The Glassware washer has the ability to skip an active segment. Press and hold the
Active Segment for 3 seconds to display the SKIP STEP? confirmation. Touch [OK] to
skip the active segment. If the skipped segment is a wash or rinse the glassware
washer will perform a drain step and then continue with the next programed segment.
When complete, the segment will display a yellow check mark. Press the yellow check
mark to display the non-fatal error. A non-fatal Skipped Segment Error (SS) will be
recorded in the data log.
Pause
Touch the Pause Icon (Fig. 6-3). A pop-up confirmation will display, select [OK] to
pause the wash cycle, or select [Cancel] to return to the Home Screen. The program
will stop and the Start Program Icon will return. Once the program is paused the door
can be opened by pressing the OPEN button (see Fig. 6-1). To resume the wash cycle,
close the door and touch the Start Program Icon, press [OK] to confirm. The washer will
resume the cycle once the internal temperature stabilizes. When the cycle resumes the
estimated time remaining will begin when the pre-pause system temperature is reached.
When complete, the segment will display a yellow check mark. Press the yellow check
mark to display the non-fatal error. A non-fatal Program Paused Error (PP) will be
recorded in the data log.
Cancel
Touch the Cancel Icon (Fig. 6-3). A pop-up confirmation will display, select [OK] to
cancel the wash cycle, or select [Cancel] to return to the Home Screen. When a
program is cancelled the washer will drain and when complete, display a red X at the
segment in which it was cancelled. Press the red X to display the fatal error. A Program
Canceled Error (PC) will be recorded in the data log.
Chart
Touch the Chart Icon to display a chart of the current program’s data set as defined by
the systems available sensors and the user’s requirements. See Chart Data File later in
this section for more details.
To Next Page
Loading...
Need help?
General
