62
Network
Modify Network connection specifications, if the optional Ethernet Connection Kit
(Catalog Number 4678000) is installed. Refer to instruction sheet included with the
Ethernet Connection Kit for additional information.
The most common setting for network connectivity via an Ethernet port is DHCP
Enabled. This settings allows the facility’s network to dynamically assign an IP address.
Reference Fig. 6-23. Touch the toggle next to DHCP Enabled to change between
enable / disable. When enabled, the remaining fields will be grayed out, as these will be
assigned by the facility’s network. If the field next to IP Address is populated with four
sets of numbers (each separated by a period), the washer has successfully received an
IP address from the network. Please consult your IT department for additional
assistance.
If a static IP address must be assigned by your facility’s IT department, set the DHCP
Enabled toggle to Disable. Contact your IT department for the appropriate information
to enter into the remaining fields.
Figure 6-23
To Next Page
Loading...
Need help?
General
