69
Diagnostics
The Diagnostics Screen is used to test washer operation/components after installation
or should a problem occur. Each electrical component can be turned on individually, or
single operation can be tested, such as Fill or Drain. Reference Fig. 6-30.
FILL ALL THE WAY: Fills to the set point level via the hot water supply
FILL ALL THE WAY PURE: Fills to the set point level via the Pure water
supply
DRAIN ALL THE WAY: Drains washer for 3 minutes (drain valve & drain
pump)
SERVICE CYCLE: A short program to test fill, wash, drain and dry
WASH PUMP: Operates the Wash Pump for 10 seconds
HEATER 1: Operates Heater 1 for 10 seconds
HEATER 2&3: Operates Heaters 2&3 for 10 seconds (3 Phase units only)
DRAIN VALVE: Operates Drain Valve for 10 seconds
DRAIN PUMP: Operates Drain Pump for 10 seconds
PRINTER TEST: Test Printer function (if installed).
Manual/Auto Run Tests: Automatically runs a diagnostic and checks
amperage draw on all low voltage components below.
o FILL VALVE (HOT TAP): Operates Hot Water Fill Valve for 10 seconds
o DI VALVE (PURE): Operates Pure Water Fill Valve for 10 seconds
o DI PUMP (PURE): Operates Pure Water Pump for 10 seconds
o DETERGENT CUP: Operates the Detergent Cup (recommend closing
Cup before running – after test the Door Detergent Cup should be
open)
o DRY BLOWER 1: Operates Dry Blower for 10 seconds
o ELECTRONIC COOLING FAN: Operates Fan for 10 seconds
o LED LIGHT: Operates Door Window Light for 10 seconds (if installed)
o DETERGENT PUMP 1: Operates Auto Detergent dispense pump for
30 seconds (if installed)
o RINSE AID PUMP 1: Operates Auto Rinse Aid dispense pump for 30
seconds (if installed)
o DOOR LATCH: Opens the Door Latch
To Next Page
Loading...
Need help?
General
