Page 13
DATA Menu Interface DATA
From the DISPLAY mode, press and then use to
scroll to DATA. Next, press
to enter the DATA menu. Use
until desired item is displayed.
Use DATA to view information stored in the M2 Unit
Controller.
RUNTIMES
HISTORY
SENSORS
NETWORK
FACTORY
STATUS
DATA
Use
arrows
to
move
DATA > RUNTIMES
In the DATA menu, use until RUNTIMES is displayed.
Press to enter the RUNTIMES menu.
View accumulated runtime hours logged against various
components and systems by the M2 unit controller.
POWER ON
FILTER: XX HRS
BELT: XX HRS
UV LAMP: XX HRS
BLOWER: XX HRS
COOLING COOL#: X HRS
HEATING HEAT#: X HRS
FREE COOLING: XX HRS - XX CYC
FANS FAN#: X HRS
EXHAUST STAGE#: X HRS X CYC
REHEAT: XX HRS - XX CYC
RUNTIMES
Press select but
ton where shown;
otherwise, accu
mulated runtimes
will display (if con
figured with listed
option) while
scrolling down.
INST: X HRS
Use
arrows
to
move
DATA > HISTORY
In the DATA menu, use
until HISTORY is displayed.
Press to enter the HISTORY menu.
Read the accumulated historical data of alarms, status, and
USB reports logged by the M2 unit controller.
ALARMS (###) ALARM
STATUS
LAST USB REPORT
READ INSTALL
!CLEAR!
Use the up/down arrows to scroll
through a list of ALARM events.
!CLEAR” flashes 3
times; then alarms
are cleared.
CLEAR
HISTORY
HISTORY
Use
arrows
to
move
DATA > SENSORS
In the DATA menu, use until SENSORS is displayed.
Press to enter the SENSORS menu.
View the current sensed value for various systems being sent
to the M2 unit controller.
TSTAT
BLOWER SPEED
OAT:XXºF
RAT:XXºF
DAT:XXºF
ZAT:XXºF
IAQ (PPM)
SMK: OFF/ON
RH: XX%
IE: XX MA
OE: XX MA
GLO: OFF/ON
DI2: OFF/ON
DI3 OFF/ON
DI4: OFF/ON
SENSORS
As each sensor is listed, its
reading is automatically dis
played.
G:ON/OFF
W1:ON/OFF
W2:ON/OFF
Y1:ON/OFF
Y2:ON/OFF
OCP:ON/OFF
Use arrows
XXXX
XXX
Use
arrows
to
move
To Next Page
Loading...
Need help?
General
