Removable tape
Remove the microphone
Make sure the following FRUs (CRUs) have been removed.
“Remove the LCD module” on page 45
“Remove the LCD bezel (with removable tape)” on page 48
“Remove the hinge cover” on page 48
“Remove the microphone rubber” on page 49
“Remove the LCD panel” on page 49
Step 1. Remove the two pieces of microphone board conductive tape.
Figure 38. Remove the two pieces of microphone board conductive tape
Step 2. Disconnect cables connected to the microphone board. Remove the microphone board.
Figure 39. Remove the microphone board
Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following
replacement parts:
Microphone board conductive tape
Microphone board
Chapter 4. Removing a FRU or CRU 51
To Next Page
Loading...
Need help?
General